Install it yourself

Two wires, and your boat is on the map.

Fitting a Dhuveli tracker takes about half an hour with basic tools. Only the power wires are needed. The other four are optional extras for the engine, fuel, alarms and switching.

  • About 30 minutes
  • 2 wires required
  • Basic tools
Required

Power: red and black

This is all most boats need. With power connected, Dhuveli shows the position, every trip and its history, and tells you each time the boat is switched on or off. On a vehicle, also connect the white wire to the ignition (below).

Tracker Meitrack T711L FUSE 1–2 A optional RED BLACK Bus bars + after main switch − negative WHITEBLUEGREENYELLOW Not connected Optional. Cap each end with tape or heat-shrink. If you fit a fuse, put it as close to the bus bar as you can. Tracker Meitrack T711L FUSE optional RED BLACK Not connected White, blue, green, yellow are optional. Cap each end. Bus bars + positive, after main switch − negative If you fit a fuse, put it close to the bus bar.
You'll need Screwdriver Crimp tool Heat-shrink connectors Cable ties Inline fuse optional
  1. Choose a dry spot with a view of the sky

    The tracker's GPS and mobile antennas are inside the case. Mount it label side up, under fibreglass, wood or plastic, never under metal or inside a steel box. Keep it out of standing water and engine heat, and fix it so it can't rattle.

  2. Red to the positive bus bar

    We recommend the boat's positive bus bar, after the main battery switch (12 or 24 V). Then every time the boat is switched on or off, Dhuveli records it and can alert you, and the tracker's own battery keeps it reporting for a while after. An inline 1–2 A fuse is optional, and good practice.

  3. Black to the negative bus bar

    Connect the black wire to the negative bus bar or a solid ground point. Use heat-shrink connectors, marine grade on a boat, and seal every joint.

  4. Check it on your map

    Within a few minutes the boat appears on your live map with its supply voltage. Take it out for a short run and its first trip shows in the trip log.

A tracker bought from Dhuveli comes registered to your account and set up, so it shows on your map as soon as it has power. Already have a tracker? Send us its model and IMEI and we'll connect it.
Optional

The other four wires

Use any of these when you want more than position and power. Connect what you need, then tell us which wire went where and we'll set it up on the tracker from our side.

Recommended for vehicles

Ignition: engine on and off, and engine hours

Connect toA feed that is live only while the key is on: the key switch's ACC or ON terminal, through a 1 A fuse. You also get a steadier parked position.

Also works with
  • Bilge float switch
  • Hatch or door switch
  • SOS button

Fuel level, from the gauge you already have

Connect toThe sender wire at the fuel gauge's S terminal. The gauge keeps working, and the tank level shows on the map.

Also works with
  • Second battery voltage
  • Alarm switch

Temperature in the fish hold, ice box or engine room

Connect toMeitrack 1-Wire temperature probes. Several probes can share the one wire.

Also works with
  • iButton driver key
  • Alarm switch to ground

A switch you can flip from the app

Connect toA relay coil: relay pin 86 to fused positive, pin 85 to yellow, and the load on pins 30 and 87.

Switches
  • Siren
  • Deck light
  • Pump

It switches to ground and only drives a relay. Never connect a load to it directly.

Insulate every wire you don't use. A loose wire that touches metal makes the tracker think a switch is turning on and off. Cap each one and tie it back. On a boat, never wire anything to stop the engine or cut the fuel.

Before you close it up

  • The boat shows on your live map, with its supply voltage.
  • Every joint is heat-shrunk and sealed.
  • Each wire you didn't use is insulated and tied back.
  • The tracker is fixed down, label side up, with nothing metal above it.
  • If you connected an optional wire, you've told us which one and what it goes to.

Rather we fit it?

Our team installs and sets up trackers in Maafushi. Tell us about your boats or vehicles and we'll quote.